CARLO GAVAZZI WM23-96 - PROGRAMMING Uživatelský manuál stáhnout pdf (Strana 23)

▲

Installation

Available Modules

Reset of min and max values

■ Preliminary operations

Before switching the instrument on, make sure that the

power supply voltage corresponds to what is shown on the

side label of the relevant module.

■ Before mounting the modules

To know in which slot every module is to be mounted,

refer to the figure on page 24. For a correct mounting of the

instrument, insert the modules in the relevant slots, then, at

the end, enter the central module, which can be a blind type

module or an RS232 communication module. The central

module will help fixing also the other modules in the relevant

slots. To remove the modules use a screwdriver as shown in

the picture below.

Gently depress the

two fixing tabs.

Directions 1-4.

Remove the central module

from its slot: press your

thumb towards points 2-5.

Extract the

central

module.

Any other slots that you haven’t

used must be filled with the rel-

evant blind plug modules sup-

plied with the instrument.

Gross Automation (877) 268-3700 · www.carlogavazzisales.com · [email protected]

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Žádné komentáře

CARLO GAVAZZI WM23-96 - PROGRAMMING Uživatelský manuál Strana 23